I have PLENTY of throw with my DX3S Marine radio for the engine kill. You guys are considerably faster than me, and I should have enough motor to run those numbers (mid 50's) I have a good Bonzai clutch, but may eliminate it for some extra speed. Or you can get a good clutch from I think BH Hanson. If you still have a stock clutch you just as well get rid of it and get use to running without a clutch. I bought a new futuba and it has a lot more forward throw for killing the motor. My JR controller that came with the oat was hard to do this. You will need to try an set the idle up high so it will idle in and then push trigger forward to kill motor.

What about in turns if you lift completely? So how much different is the driving when clutchless?Ĭan you let off the gas and let the boat stop, or will it stall? The down side to this is if you break a flexshaft you los everything in the lake. You would also need to give more gap between the strut and the drive dog (1/4').

You will get one that is way to long and you'll cut it whatever you need it? You would still need drive dog, prop nut, and round collect. You also would not need to wait on the flex shaft since it is round. Then you get the 5/16' brake line put it through your strut and into the end of your stuffing tube (this makes it all solid). PS: If I had t to do over I'm not sure I would go solderless? I think getting a round collect, welded prop/flex shaft from accu tech.

I drilled the hole out also so I can shoot a little grease in it). Not sure how this is going to work but it is the full length of the strut instead of just on the ends. I had them square off the ends a little further just in case it was to long I could cut t off.ġ/4' Strut bushings (I got this at first and have now switched to a 5/16' brake line from the automotive store. Once you install your new parts you can measure how long the flex needs to be and then order it? I figured out how long mine needed to be and told them to send me that length (They really did not want to do this but they did). WHH makes you order all the parts except flex shaft.

When you make this change you will be switching to 1/4' prop shaft.

Blackjack rc boat 55